Recent content by Zrxpilot

What he said ^

2014 ltx. Done nothing more than 8dn, mbrp trail can. 93 every day. Was surprised how well the sled took to trail can. It isn't any faster but runs well with it. Just bolted it on. Sounds nice too. Has a little something but not enough to get a ticket.

Fwiw...14 ltx. 1900 miles. Factory original flash, stock battery always on a tender when parked, never had a kickback.

I had a nytro and would never go back. It was fast enough and gave me zero trouble in the 3 seasons I had it. Despite this, it was cold, rode very rough ( even after a custom revalve) and steered very hard. Too much weight on the front I think. It was a fun sled to ride hard for short...

I did nothing more than put on a set of dually carbides, removed the transfer blocks, messed with the front limiter strap a bit, bolted on an msrp trail can and shimmed the secondary. This plan didn't cost me much and hasn't been much trouble. I also run battery tender all the time. This sled...

The pics below show the completed effort so far. I think I need to move the activator somewhere as there is no way its going to stay put where it is.

Installed most of this last night. Not sure if I extended the groove enough. I cut it just enough that the spring would mount into the existing hole plus maybe 1/8" or so. Used a drill bit and a file. Took out maybe a 1/2" or a little more. It fits. It also appears I need to relocate the black...

Found the posting about it. I just bought an 8DN-17641-01-00. Looks like I might be shimming my secondary again.

I assume the 01 is the later version?

I recently purchased an Aluma brand 7712H open trailer with the front shield. Bought it primarily to haul my RZR around. I had intended at a later time to upgrade to an enclosed of similar size but economics is not going to allow that at least for this winter. Anyways, for those not familiar...

Started up my sled today. Noticed crap flying around. Assumed a critter nest. Found what's left of an 8DN belt with the top layer threaded. Was a new belt when I put it on but purchased back in 09. ( My spare for my nytro.) This belt has maybe 10 miles on it. Thinking just an old belt that...

Thank you. Still not clear to me whats involved but I ordered the parts. Probably figure it when I see it. Nice guys up at PartsPak if you have ever used them before. $118.30 and a little bit of shipping.

Installed the kimpex seat yesterday. Set aside a couple hours. Install is straightforward but you do need to pay some attention as you can screw up. Particularly with the hole drilling. I do like it as I think your passenger will. Installs / removes in 30 seconds.

Do you think it could be made to work with the 137?

I am gearing up to set up my ride for two up. Thinking I probably need to change out the standard torsion springs for something heavier?