Search results

Check your chain tension and also belt tension. The 3 adjustment bolts on the back of the secondary tend to use up, causing more tension on the belt, making it very hard to shift. I had to change those 3 bolts at around 7000 kms. Dealer had lots in stock so I'm assuming its a common problem on...

I've got brand new 2023 ZR200. Ran great the first 5 minutes, then kept bogging out when giving it more than 1/4 throttle. Opened the cab and found the air box lid was off. Looked for the bolt everywhere but couldn't find it. Put a new bolt in and runs like a charm. I've seen on other forums...

Yes its the one closest to the rear. You ha e to remove the bolt that holds the clucth in place. #24 in the above picture. Torque spec when you put it back on is 46 ft-lbs

Item #8. There are 3 bolts. On the back side of the secondary clutch. And yes I ordered from the dealer.

I removed mine on my 2014. Kept getting caught in the tunnel. Never overheated my machine. It will fill my sleigh with snow now, only downside.

Just thought I would post how to fix this issue. I had very bad belt squeal at idle and it was very hard to shift from any gear. I replaced the 3 bolts for belt tension on the back of the secondary clutch. They were used about 1/8" and my belt tension was way too tight. No more belt squeal and...

I haven't done the jackshaft bearing yet. I plan on doing the chain and all the bearings in the chaincase this fall.

That's what worries me the most is the chain/chaincase. I'm not worried about the motor. I have a 2014 Pro with 7000 kms on it. I put roughly 1000 kms/year but always pulling heavy. I have a homemade 52"x16' drag out of 2x4 HSS with a chipper knife and brush bar on it. Its about 12 km's to my...

Hi everyone, just wondering about mileage and maintenance done on your VK's. Any high mileage VK's out there? What have you done for maintenance/major parts replacement? Thanks in advance