Search results

trip is on the 23rd to 28th are trails ok is their enough snow i see they are to get a warm up , is it ok at this time it is getting tough to find snow.

anybody useing the pro line clutch kit , if so how do you like them , are they easy to tune , what is your enguagement , was thinking of going to another kit with my RX1 MPI S.C 7 1/2 LBS , is your belt cool , do not want one that burns the belt. thanks

i bought the p&p kit getting ready to stsrt sled have a question on wireing this is on a 05 rx1 with 07 bars , do i just plug in the yellow from the WHC straight into the yellow/red from the other heaters?? also i don't use the black wire from my other heaters?? hope to here soon, i could...

right now i have super tip weights primary spring opo sec spring silver and helix marked s (this is ulmer kit) this has been in sled for about 3 years now i tried his set up but clutches were way to hot , my question is if i remove mid washers would this make it pull harder or am i wrong set...

have 2 05 rx1's both doing the same thing.. when you turn the handle bars left or right bars move 2-3 in's before anything else turns must be something easy just don't know where to start or adjust to tighten up steering . any help would be great.

i am going to swap out my mono susp. if it breaks again , i should say when it breaks , where are you guys getting the zx2 from , it will be between the zx2 or a fast m10 or the air ride. thank you

first off in 05 we bought 2 yamahas 1 rx-1 & 1-rs-vector , we took their advice & bought the team rollers . my question is on the vector, i have 2 helixs one is 34-strt 50-34-46 other is 38-strt 54-38-46 (which came off my rx-1 ,did real good on that) both have red-pink spring...

how much weight do i put in the supertips? and where. low elv, 136 track, 25 gear, 24-24 pulleys , to run 10200 rpm pin weight center tip- thankyou

this may sound dumb to some of you guys but my questions are , put 24-24 pulleys on ran sled on hoist my boost guage reading was 10-14 lbs low alt. when the sled hits the snow is this what it will be at or will it come down (stock motor, and yes i did try another guage) a/f readings...

took out o5 mono suspension to grease everything and replace all plactic bushings & 1 bearing upper rear wheels have 2 spacers , one is larger od did not watch how they were in place. need to know how they go back in , is it large o.d spacer then the wheel then smaller spacer then plactic...

ordered the dynotune afr guage , weld on bung comes steel or stainless steel , which one will weld to stock exhaust or should i get the titanium one from mpi. also what type of welder is needed. thanks

want to change needle clip, pulled the top off of the carb pulled out slide and needle, my question is how do you get the needle out of the slide it looks to be all plactic do not want to break anything. thanks

this is my first post hope it works. bought a mpi supercharger for my o5 rx1er , started to install it on sled , i got to the point where i think it is to much for myself. i need to know if anybody knows of a shop where i could take sled & supercharger and have it installed properly. thanks...