brace for dished out tunnel?

[rock doc]

hey gang

The top of the rear tunnel is dished out on my 141 XTX and the brace under the twilight is bent. I installed a new piece of angle but it did not hold. I have been trying to find a rear tunnel brace or top carrier. looked at the pro climb bracket. will this work? Any other options? most stiffeners only run down the sides of the tunnel.

 

[Kuzzy]

I went with cr racing bumper and inside braces, I now hold a 20L plumbed in slip tank, no issues and I ride pretty hard on my 146 xtx. I also put in a stingray spring, I felt that a big cause of the buckling was from ice freezing and starting the buckle at the end of the running board and then bottoming out. With weight on the tunnel it simply bends.

 

[mrtwostroke]

I put this on my MTX works grate.

Yamaha Viper/Sidewinder Tunnel Stiffeners 2014-2021

www.blingfactory.fi

 

[rock doc]

that looks fantastic. where did you get it?

it was considering a similar option with kimpex. the last connect system seems ti move the weight from the middle to the side of the tunnel.

 

[Kuzzy]

I put this on my MTX works grate.

Yamaha Viper/Sidewinder Tunnel Stiffeners 2014-2021

www.blingfactory.fi

i like how clean that is

 

[THEPASMAN]

Account Suspended

Pretty slick setup

 

[Kuzzy]

A bit hard on the eyes, but I can count on 300km easy without refueling

 

[mrtwostroke]

Powderkeg and blingfactory.