Rear Aluminum Pivot Arm bolt Torque Spec

[Mark Vance]

Can anyone tell me the torque spec for the bolt that clamps the rear aluminum pivot arm to the Rear top Suspension arm? I had to remove the top rear idler wheels to replace them. 2018 Sidewinder LTX-Le 137. It has a 13mm nut and 10mm bolt.
Torque spec sheet I have it wasn't clear and didn't want to over or under torque.
PS 9800 miles on the original top idler wheels and bearings! not bad.

 

[DMCTurbo]

45 ft/lbs

 

[Mark Vance]

Thanks for the reply... this is the bolt I am try to determine how tight to torque. It wasn't very tight when I removed so i don't want to over tighten. Thanks again.

 

[earthling]

I think those small lock nuts are 20ft lb.

 

[Mark Vance]

Thanks... much appreciated!

 

[FrozenTows4]

20 ftlbs is correct.

 

[DMCTurbo]

Ok I was thinking the bolt to fasten it to the tunnel.

 

[Sevey]

Most of the fasteners on these cat skids are like 10mm and 13mm. They dont need a ton of torque. A decent 3/8 drive ratchet and make snug, tight and one more little bit - and that will be an easy 20ft lbs.

MS

 

[Mark Vance]

Thanks... much appreciated everyone!