Recent content by brinkkl2000

Great, going that is all it is. Does the suspension have to be dropped to change it, or can it be done from the side of the sled. Never been in to this one before.

That's kind of what I am hoping it is, just found it strange that it would cause the engine to act up.

So, I haven't done too much diagnosis yet but thought maybe someone could give me direction. Was out on the trail today and I heard some rumblings by the clutch area, almost as soon as I heard it the sled shut down. No lights or warnings came on prior. Fired it back up and it idled perfectly, as...

Thanks for the replies everyone. At least I know it is fairly common. Doesn't matter too much anymore as this past weekend up north the drunk behind me didn't react me stopping to help a fellow rider pull his sled out of the ditch and banged in to me at about 30-40 mph. Although the damage...

This has kind of been bugging me for a couple years, its nothing major I don think. When the sled is hot/warm, like when we shut down on the trail for a few minutes, I have to blip the throttle when cranking to get it to fire up, otherwise it will just crank and not start. It runs perfectly...

Have a 2012 Apex EFI and if course as I was all excited to go ride today it started acting up. Been idling fine until today when I want to use it. It started surging at idle first, sounded like tors was acting up and I had op-lo on the screen. Last year the previous owner tried removing the oil...

Grand Rapids, Michigan

Nitrogen charged?? Guess I will have to bring them somewhere then. Is the dealer pretty much the only ones that can do this, or would a good shock guy probably be capable.

I am quite mechanically inclined, I am not looking to revalve the shocks, just replace seals and fluid, unless these are gas charged...

I have a 2004 RXWarrior and was wondering about rebuilding the shocks. I am wondering if they are even rebuildable. The fronts shocks are aluminum body with full threaded preload adjustments, the center shock is the same, aluminum and threaded, the rear shock looks like it is a steel body with...

Went with the Dayco. Anyway went out with the guys Saturday and it ran great! Didn't hang up a single time. I did notice a slight squealing when the clutch engages the belt, but other than that I am happy. Thank you so much guys. I would have never thought driveline would cause that kind of problem.

Anyone have any opinions on drive belt? I am looking at Gates G-force carbon belt or Dayco Ultimax XS.

I think I combined a couple of suggestions, check the driveline/ clutch, and then per my usual; way of going about things I went for the most expensive option. Anyway, I pulled off the belt and ran the engine smoothly through the entire rpm range a few times. I put the spare belt on instead of...

Here is an update, we finally have enough snow to check it out. Put on the new "used" clutch and have no change. I did not pull the clutch itself apart to check the weights and rollers on this one. I noticed that when I let off the throttle the sled slows down very quickly, almost like the...

I don't know yet. We got 2 ft of snow over 4 days just before Thanksgiving then lost it all in just as few days. Waiting to test it out. I did pull the clutch and it appeared as though the weights and a couple rollers were worn. It would have been about $400- $500 to get a clutch kit and...