Recent content by DK1975

Some of the elbows are undersized not letting the excess pressure return qhick enough, simply need a new elbow

the one I just did was hanging at 2600 - 2700

yup, it will be ...... been on a hunt for this for a while now !

Bring your sled into your dealer and have them do a fuel pressure test on it, more then likely the elbow from the fuel pressure regulator is undersized, its the red elbow that goes into the tank, more then likely the fuel pressure will be reading very high, just had one in the shop with this issue

I'd be willing to bet your replacement motor was a new style motor also, if that's the case it's to be expected. hopefully you get a new motor and rods and never have an issue again

Ya revived my first 2 orders of rods .. first motor is back together .. will be running Monday

expecting my first order of rods in tomorrow, friday the 16th, already pulling my motor out

ya only yamaha part # mpi turbo kits

I use a mighty vac on the hose to build pressure to get it close then test run to dial it in

all sleds excluding early build ltx le and mtx 162 le

Info released to dealers here in canada yesterday, kit has new rods, piston pins, rings, all gaskets needed, and all bolts needed

Your dealer should be doing the low altitude re-cal automatically, my self I would clutch a little heavier then they will put in,

flash only takes about 10 min to do ! nice and simple

Just putting our first ones together, 8jp belts on them

you should be able to get that right from your yamaha dealer, part # SMA-HSO16-00-00