Recent content by JD

Ok peoples......Sorry for the slow update on my shacking/Vibration issue.... The dealer did install a new track for me.....he said yamaha was not paying for it which is ridiculous....Anyway...got my choice of track, which was nice so I selected (recommended by camso) the 1.5" crossover.....and...

So what the dealer told me was that my gauntlets on the handlebars were interfering with the TORS system.....I'm a bit sceptical on this as I did put on 750 miles prior to this with those gauntlets on.....I could not duplicate the problem as hard as I tried by wiggling and twisting and...

It,s not going out after 10 or 15 seconds....that's long enought running I figure. Called my dealer today, hopefully tomorrow I can get it in. And yup....still got 2 years warranty...sure am hoping it's a connection or sensor of sorts... Will post the results for you guys...thanks

Thank you......will check to see if its unplugged or something.....hoping for "simple".....praying it's not a pump problem......Thanks again

Hey guys....I just fired up my sled (2016 RS Venture TF LE)....I have the LO OP flashing on my gauge pod and the yellow warning lamp accompanied with an engine and oil lamp.....the engine will not idle, it revving up and down, some engine protection no doubt.....any idea where I should start...

https://ln.sync.com/dl/b24ef2870#8auvb27y-ed2zgb3s-de2rtmnn-nzrzp4jk If anyone would like to see and hear the track, click the link above...hopefully it works.....Only sad thing is...my big A#@ is in the way of the sled...but you can clearly hear the track shack...I throttle up to about 30 mph...

I have made enought calls and trips there already...I am out of patience for that....And my toys are always stored inside....I wasn't about to let it sit there all winter while I was also trying to enjoy a bit of riding...May be I should have....I am going to try and upload a vid to see what...

So... I finished off my riding season with the same track problem I started with....The dealer is on the fence with the source of the noise/shacking...I have shown several riding buddies and we all come to the same conclusion that I have a dud track....The dealer has sent video and email's to...

I used to put about a half can into my oil tank and do one short, 20 mile ride before an oil change......(on an 03 RX-1 Mc Express turbo).....then dump the oil.....Don't forget that with that small amount of oil that stays in the engine there will still be a trace left behind after the oil...

Did Camoplast actually admit that they have a bad batch of tracks.....I am still struggling with my dealer to convince them and Yamaha that the track is the source.....

Does Yamaha make a 13mm bar? I am just looking to swap out the one on my 2016 RS Venture TF LE.....I had replaced the one on my 03 RX-1.....with a Yamaha bar....It made a world of difference on the corners....the venture likes to roll, the stock bar has got to go.....

You know what...I may try that, just for the heck of it....Not this week is all, as I am all lined up and tensioned up for a weekend ride...If its still doing it with no signs of fading I may just try it after that......Thanks.....I will update with the outcome... :~)....Hey did anyone try my...

Yes....Ran it today with a second brand new belt....Looks and measures up the same as the factory installed belt....So the belt made no change....I'm ruling that one out.....I have no doubt that it is narrowed down to the track...

Ok...so to respond to the last post...the track actually was very loose.... I did bring to spec.... here is my update: I decided to run the sled today.... after spending so much time looking over every area of the sled that could be suspect...I decided that it is most likely coming from the...

The track is lined up nicely...all wheels are free...no wobbles...no flat spots.....What do you mean when you say "Maybe the track needs to be pulled"? If you mean tension, it is set correctly. I just spent about 3 hrs looking over everything again....I have replaced the belt and will try it...