Recent content by Philscbx

If you look quick, there's an engine on ebay w/3200 miles on it. http://cgi.ebay.com/ebaymotors/Yamaha-R ... 640wt_1023 I never did master micro links. 20 hours as of now left.

To make sure I follow, as hard to load. Are you referring to crowded space with other sleds? This is what I heard from member I talked to the other day, not as severe, but enough to where they didn't get ordered. To be honest, I forget how wide the 03 RX1 er is on ski center. If that's the point...

The hyfax if that's what your referring to will force through. Melting, that would be like melting a tire. But if trimming helps, dremel could do it easy at 20,000 rpm. A little squirt of silicone at the hole will let it slid through easier. Once you get it started out the hole...

Alright, a neighbor. With temps that low, I bet it did take a while. Heavy plastic window rap as tent and small heater would add major speed. On the other hand, you may have gotten the best density with it cold.

Just wanted to make it known that your shots are perfect. Hope it gets sorted out. That distance does look a little too deep into striking zone. If it had pivoting spring pressure like belt tensioner, maybe.

I could swear Your Right, but it was a pair next to each other.

There are plenty of wheels out there, from cheap to insane. Google or here may get you plenty of results.

Was the oil level checked?

It would sure do wonders if the site could deny registering with that field blank.

I have not mounted my Simmons yet, but I can't imagine anything turning on a dime better than these.

RX-1 Maxximum 44" Front End This link doesn't have any resource of where the parts are. http://www.totallyamaha.com/snowmobiles ... 1FrontEnd/ Google search, and countless search here have zero results. This search has me wondering why you don't see any topics of who have tried wide...

To verify flooded or starved, and starved is more than likely. My 03 needs a squirt across the carbs regardless how much choke I try if it sat extended. Recharge, do the squirt, and immediate fire. It would be nice to insert a window in fuel line to verify flow from pump, but I suspect your...

I think you are on the right track, but the difference might not be noticed. Lets assume the new hole increased the spring rate by say 7-15 pounds, would it be noticed is hard to say. Even though it helped. I've given a lot of thought over the years, even to redesign an existing compound...

The option would be look for heater, one that fits in the coolant hose. We used stone age tank heaters in the 60's in vehicles. But at 40 below, 4 strokes regardless the vehicle, diesel or gas, truck, car, etc are 50 more parts glued to the surface that is now frozen tighter than it was...

I would do like I did and remove all the A arms and lay them on a flat surface and see if the bolts pass through the ends squarely. If not, a hyd press can be used to tweak them back little by little. Get the A arms square to the world, then see what's next in line. Hopefully your not...