Recent content by stubb111

m.shuey.....here's a link to my build below, it has sit for the 2 years in back of garage at old house and a year in the new shop due to life just being too busy. it hit the snow for about 3kms end of last winter and will get a little bit of riding this winter but, not too much due to being...

have my 09 xtx working amazing on trails.... it has quite a bit of things done to it, for handling skinz a-arm kit, oft steering relocate, fox float evol x shocks with high & low speed compression and rbound adjustments, 7" mountain skiis with snowtrackers (semi-agressive) on the fron end...

m.schuey......do you run your 1.5" croosover studded?

m.schuey.... i have a quick question, are you running the 1.5" crossover track studded? I am changing the track on mine shortly (22,000km on the stock ripsaw) and would like to run 1.5" studded or maybe the 1.6" ice cobra. thanks

and rubbers....if you want to do it right

single keel yamaha mtx are great with semi agressive snow trackers, work good in snow and trail

Devil.... I tossed Timbersled mountain tamer into mine with the stock rails, does not get much lighter than that when done with fox air shocks. It is a trail sled set-up and plenty tough, it has taken some abuse.

are those simmons gen2 (10" wide) skis???

yep....that happens, must of hit something.....if your sub-frame doesn't bend then something else will in that situation (a-arm) and it is easier to ride home with a bent sub-frame than a broken or bent a-arm. unique repair method....

stock skis with snow trackers (I prefer the semi-aggressive, tried aggressive....same for turning just a bit harder to turn). look into setting up your front end, a arms should be almost parallel to the ground.... a few really good posts here regarding front end set up.

VERY NICE....haven't been here for a while, and stumbled across your build which is very impressive. Thanks for sharing it. cheers

PM me your info or i will email or text you pics, i haven't been here for quite a while and having a hard time loading pics

there are spacers between the spindles and skis, as the openings are pretty huge. when doing this setup i spent almost on hardware as it cost for the take off skis. the wide saddle openind does allow for quite a bit of adjustment in width as a result. i can take some pictures in the morning for...

my xtx used to ice over all the time i moved it towards front of seat closer to exhaust and it is better there but, i think that's where where the short track is mounted.

only change was 0"/mm toe in as per the kit....i have done alot of suspension stuff to it over the years, it is pretty spot on now. i have a couple of things i might do this summer though