Search results

yes, that should be the correct one it is red in color and solid state, just ordered one up for my sled.

Have a 07 gt, and put an ulmer clutch kit in it and dropped to a 18 tooth gear, rpm and runs perfect. just seems to push more in the front end with the 136 track.

Thanks, guys, I knew I saw it somewhere just couldn't remember where.

07 phazer gt left me stranded on the trail and I had to be towed home, first time I have been stranded by the phazer at 10,500 miles, but thanks to this forum I figured out the ground wire in the yellow connector was bad. Does anyone have a link or a copy they can send me for this service...

Damn, I figured it out after looking at wiring diagram and troubleshooting in service manual , The 4 amp fuse was blown (it is in the smaller fuse box). There is also 3 relays in the system. Yamaha sure made what should be simple, complex!!!

Sometimes you just get thinking. Anyone know how many new style phazers have been manufactured since 2006? and how many old style pogo stick phazers were manufactured?

I push the reverse button and the r light starts flashing, I don't believe it even tries to shift into reverse, but I did not probe wires at servo to see if voltage is going to them. How ever in order to to get back into drive mode I have to turn the key off( it will not go back into drive...

As a follow up, upon reinstallation I removed the long bolt for the engine and also removed the upper chain case bearing for replacement and was able to put gear box in with out servo motor attached. It was very tight but doable by prying up on engine. Then put a new upper chain case bearing...

I have 10,200 miles and just rebuilt both shocks rebushed and greased rear suspension and have more sag than I feel is acceptable. I think the gt torsion spring is 2100 and the fx torsion spring is 2500. I have installed the high gear bushing at about 5,000 miles and that had helped greatly...

My phazer is 300 miles away, I think my engine rpm may be set to high. Anything else to check next if that is not it. I had the complete reverse gearbox out, checked everything, replaced both sensors and by using 12 volts directly was able to shift the servo motor for forward and reverse...

Down-rite, were you able to remove the whole reverse gear box as an assembly ? Did you have to take the internal bearing in the chain case out ?? thanks for the info, frustrating is an understatement, my 07 phazer just turned 10,200 miles, I think the only thing I have not had apart is the...

In the owners service manual is says you can remove the reverse gearbox by removing fuel tank, exhaust system and pipes. I could not get my gearbox out with out hitting the engine block(even removed internal bearing in chain case). I ended up splitting the gear box in half to get out for...

Custom Axis x 2, work excellent!!!!

One other thing I have noticed is right after it starts it seems to idle faster than when hot, when hot the idle speed really drops off. I tried setting idle up but I think that "gizmo" is stuck beneath the rubber plug in belly pan. I tried turning it and no go. my buddies says it sounds...

Wooly, What is tps? thanks, will

I have tried holding the throttle open a little it doesn't seem to help, almost think lack of fuel, if i set the idle screw up would that help or is the same as holding the throttle open a little? I just hate keep cranking it for 4-5 times, but it always has eventually started. side...

I have 8400 miles on the sled and think it has gotten worse the last 1000 miles or my memory is getting bad.

My phazer starts great cold or after sitting 30 minutes, but if you fill it up with gas or stop and talk 5 minutes, I have to crank and crank and crank and crank. It will fire and die, fire and die, fire and die, fire and die. :o| Any suggestions thanks, will

Planning on making it to the houghton ride, never been to a ty ride before. Hope the snow holds out. Is there any agenda or meeting time when everyone meets or is it "meet and greet as you go?" I am bringing a ski doo rider along too, hope he isn't thrown under the bus. He used to ride a...

I just put a new top cover on mine and it had a cloth shield attached to it like your second picture. My shield had a ear broke off it and it didn't appear to have any heat shielding material on it originally. I have 7500 miles and I can't believe it would have disenegrated.