Search results

Just doing some regreasing on all the wheels on the Attak and the Nytro XTX, and I notice on both sleds on the upper wheel aluminum shafts, that there is some wear on one side where the inner race of the bearing sits on the shaft. Those wheels are kept in place on the Attak with a floating nylon...

April 29, I've been ice fishing before on this date, but never running 60 miles of road(near the Dorion Wind Farm) like I did yesterday, without another track in sight. Everyone else must be at home opening up their pools for the summer. Three inches of freezing ice pellets on Wednesday, two...

Here is my attempt to come up with a mirror that suits me. I do like the look of the OEM Yamaha handguards so I made a bracket out of a piece of one inch aluminum flatbar(building supply store). I made most bends in the vise over a short piece of bedframe angle iron with a rounded edge, because...

12 volt heated gloves have been out for a while, and I am just wondering what the verdict is from those that have used them. Here is my issue, my hands are worn out and to make it worse, I am probably having some arthritis also. To combat the cold, I have been using heavier gauntlet mitts which...

I tried searching for flex ice scratchers on skis without much luck. So here is my install, on mountain skis, but stock skis should be similar. The 1 1/4 X 7 1/4 strap at the rear bolt, is cut from a heavier truck tire inner tube.

I lowered the rear suspension to remove the other 47 parts to install a temp guage and mtn cooler recently on the 2009 xtx, and while the back end was up in the air, I noticed a small amount of oil had dripped from the rear shock onto the inside of the track. When I grab the back end of the xtx...

For those with frequent trailer use, if you were to have a new trailer built, would you put the front unloading door on the driver's side or passenger side? Thanks.

Did mine three days ago. I read all the posts and the complaints were: broke the bolt, stripped the threads, and not compressed enough that they loosen down the road. I did some testing on the bench and ran into the same problems. I believe that the main reason is that on the assembly line, the...

I changed my oil and filter on my 07 Attak yesterday,... and today. I hope you can help with a couple of questions. I drained both the tank and the pan. When I went to refill, I put three litres in the tank through the dipstick hole. I checked the dipstick after 15 minutes and it was over the...

Will adding stabilizer in the last tank of the season, do it? Good to go in November? Any other tips for the engine?