Search results

Looking for a 2011+ apex seat pan or a seat the bad and I can get pan from

Will a gauge from a 06-10 apex work on a 2011 and newer? Or does eps work thru gauge

Looking for 4 inch rail extensions for a 2011 apex. Wanting to go from 128 to 136

I’m riding right now and the vector coolant pipe wore a small hole thru it and is leaking. Will hot light come on even if it runs out of coolant. I just keep adding coolant for now

I have an apex mtn 162 with proactive suspension. There is a bar between rails that The rear shock and 2 support bars bolt to. My question is when suspension compresses is the thing on bar supposed to swing down towards track or up away from track

My 11 apex just got new track and while adjusting it I notice as soon as I let off gas the track stops. I can turn track and clutch by hand pretty easy. Just doesn’t seem to coast. Does this sound normal because it’s hanging in air. Or is something slowing it down

2006 apex with 162 proactive suspension. I don’t like this suspension because it doesn’t seem to hook up very good. Has anyone taken the rails from a proactive and put the suspension from a mono and some other work I’m sure. Is this something that is possible?

Will a 1.5” track fit on a 2011 apex 128” with the tunnel protectors. It looks pretty tight where the tunnel protectors start can they be left in or should I remove them?

It has done this for a long time and want to know if it’s normal. When I first start apex when it’s cold it takes 3-4 times for it to keep running. It will fire then die. Also backfires sometimes on long runs when letting off gas. It’s like it’s getting to much gas or something. Completely stock...

Do all the Yamaha snowmobiles use the same belt? Talking about the 06 to present apex,vector and venture. Is the same belt used in all of them?

Looking to get a couple phazers for kids. What year or models should I stay away from? What signs should I be looking for when buying that something isn’t right?

what would happen when riding with out limiter straps hooked up? The reason is because my apex mtn has no transfer until I unhook straps. With them loosened all the way they are still tight and I get no transfer

My sled has a bad vibration was only at higher speeds now it’s starting at lower speeds. I took everything apart chaincase oil was pretty dirty but everything seemed fine in there. The only thing I found was the set screws on the bearing by the speedo sensor where missing. Driveshaft would slide...

Have a 09 vector with very noisy clutch rattle. Will the clutch from a 2013 venture fit on vector and do I have to change anything else

think I have the wrong limiter straps on 06 apex mtn. I have them all the way out and still no ski lift. Could someone measure theirs and see how long they are. Mine on the longest setting are 7 1/4 from center of bolts

can I put 06 apex handlebars with the updated wire connector on a 09 vector and have the same hot grips as the apex has?

09 vector with yamaheater on it. Grips wont stay warm. Red light comes on from yamaheater but still only gets luke warm. When I put the handlebar switch back to high the grips cool down and never get hot. I just put a new battery in could i have messed something up then? Thumb warmer works...

Just got sled and has this led light on it. Most of the time it’s green sometimes it’s red. What’s it for?

Have a 2007 apex mountain. What do i have to do to make it transfer more weight to the track? I know it it something with the rods and nuts on back of skid but cant figure it out. Already let limiter straps all the way out

I am putting a heat exchanger on my apex that i picked up at hay days. Its from a 2010 arctic cat cf8. My problem is i cant blow through it. Shouldn't i be able to or is not how they work.