Search results

Anyone having issues with these connectors? Are there any remedies? I have seen someone cut them off and soldered the wires together for a solid connection. They haven't had any issues since. I had multiple codes and a no start backfire while cranking and i ended up probing these grounds and...

just an update, I went thru the freeplay again, set it to factory specs, tightened my thottle on the handlebars so it would not move. The code was there before i tightened the throttle on the bars. When i did tighten it i also checked some of the ground connectors on the passenger side above the...

thanks for the reply's, I'll adjust the freeplay tighter although it says in my owners manual between 3-4mm so i don't think i'm far off

The throttle is a bit loose on the handle bars but it doesn't matter the position the code stays on until I physically move the throttle to engage the tors switch

hey guys, I did a 370km run last weekend. Trails were smooth for the most part but got rough in the afternoon. On the last 100km my tors started acting up. Didn't matter what speed i slowed down from, when i was off the throttle the code would come on and coming to a stop the sled wanted to...

so i went thru the wiring and found a bunch of grounds together just above the throttle bodies and right below the radiator on the left side of the sled. I started probing them to make sure i had ground. I had the key on and happened to glance over at the gauge and there was no engine light or...

Thanks I am now. I just have a muffler

I have an 08 nytro rtx that backfires while cranking and will not start. Engine light flashes and codes 13,25,84 are displayed. The story is i took it out about a month ago at first snowfall, ran like a top. I always let it warm up before moving it and a couple weeks ago i needed to move it out...

New to the forum and i love it! I just received my oillite bushings from barcode and have been surfing on here trying to find a step by step on replacing the bushings on a 2008 nytro. I can't seem to find a tutorial. Can someone point me in the right direction? Thanks!