rwill2cruz
Extreme
- Joined
- Jan 23, 2015
- Messages
- 66
- Age
- 70
- Location
- Sudbury, Ontario
- Country
- Canada
- Snowmobile
- 08 GT LTX Anniversary
Just doing the oilite bushings on my 08 Apex. I forget the orientation of the plastic cupped washers. There are 4 on each control arm bolt. I see where 2 would fit over the control arm bushings but how do the other 2 go? The parts blowup diagram does not show it clearly.
Teamblue4
Lifetime Member
- Joined
- Feb 20, 2008
- Messages
- 1,278
- Location
- Il.
- Country
- USA
- Snowmobile
- 2012 Apex XTX
2013 Apex SE
2014 Apex SE
2014 Apex XTX
flat sides towards the bulk head 2 on upper and 2 on lower a arms.
rwill2cruz
Extreme
- Joined
- Jan 23, 2015
- Messages
- 66
- Age
- 70
- Location
- Sudbury, Ontario
- Country
- Canada
- Snowmobile
- 08 GT LTX Anniversary
thanks!flat sides towards the bulk head 2 on upper and 2 on lower a arms.
IH8CROWS
Expert
I left mine out not knowing and thinking not needed with oilites. Thought they were part of the grease setup I just replaced? ? ? ?
Teamblue4
Lifetime Member
- Joined
- Feb 20, 2008
- Messages
- 1,278
- Location
- Il.
- Country
- USA
- Snowmobile
- 2012 Apex XTX
2013 Apex SE
2014 Apex SE
2014 Apex XTX
I would put them in.I left mine out not knowing and thinking not needed with oilites. Thought they were part of the grease setup I just replaced? ? ? ?
Similar threads
- Replies
- 343
- Views
- 113K
- Replies
- 6
- Views
- 7K
- Replies
- 6
- Views
- 1K
- Replies
- 116
- Views
- 46K