MFC44
Extreme
Start by trying a chisel and hammer only hitting on inner race. If that doesn't work. Take clip out of wheel and pull wheel off bearing. Then use a bearing puller remove bearing. These can be on there big time. Was just a thread on this subject. Here:
http://www.ty4stroke.com/threads/how-do-you-remove-the-upper-rear-bogie-wheels.137540/
http://www.ty4stroke.com/threads/how-do-you-remove-the-upper-rear-bogie-wheels.137540/
Last edited:
MFC44
Extreme
Thanks I knew I saw it on here was just searching the wrong thread. It is an SOB to get those off.Start by trying a chisel and hammer only hitting on inner race. If that doesn't work. Take clip out of wheel and pull wheel off bearing. Then use a bearing puller remove bearing. These can be on there big time. Was just a thread on this subject. Here:
http://www.ty4stroke.com/threads/how-do-you-remove-the-upper-rear-bogie-wheels.137540/
FrozenTows4
Lifetime Member
- Joined
- Nov 6, 2014
- Messages
- 487
- Age
- 65
- Location
- Brainerd Minnesota
- Country
- USA
- Snowmobile
- 2014 XF7000 Sold
2017 ZR6000RS
2018 ZR6000 El Tigre
- YOUTUBE
- FrozenTows1
There's a puller made for these.
Down side it they're over $300.00. I borrowed one from our local dealer. Removed both wheels in the parking lot. Returned the tool in 10 minutes. Took longer to walk back and forth than it did to remove the wheels. Are you friends with your dealer?
Down side it they're over $300.00. I borrowed one from our local dealer. Removed both wheels in the parking lot. Returned the tool in 10 minutes. Took longer to walk back and forth than it did to remove the wheels. Are you friends with your dealer?
Last edited:
Byam
TY 4 Stroke Guru
They should make the drive shaft whit that FIT. LoooolStart by trying a chisel and hammer only hitting on inner race. If that doesn't work. Take clip out of wheel and pull wheel off bearing. Then use a bearing puller remove bearing. These can be on there big time. Was just a thread on this subject. Here:
http://www.ty4stroke.com/threads/how-do-you-remove-the-upper-rear-bogie-wheels.137540/
MFC44
Extreme
Unfortunately not. My closest guy is 30 miles away Rich's Yamaha when I asked his lead Mechanic a question about a wrench for the oil filter he was less than helpful. So I assume he will be even less when I ask him to borrow the pullerThere's a puller made for these.
Down side it they're over $300.00. I borrowed one from our local dealer. Removed both wheels in the parking lot. Returned the tool in 10 minutes. Took longer to walk back and forth than it did to remove the wheels. Are you friends with your dealer?
MFC44
Extreme
Thanks for the info thoughUnfortunately not. My closest guy is 30 miles away Rich's Yamaha when I asked his lead Mechanic a question about a wrench for the oil filter he was less than helpful. So I assume he will be even less when I ask him to borrow the puller
Similar threads
- Replies
- 10
- Views
- 962