Recent content by nadekeys

Haha, small world. I have the blue Nytro, sonds. Bought it from you in Minnesota a couple years back. Going to be running it this weekend up in the U.P. I've added a water temp gauge, rear tunnel bracing, and fixed that oil leak (stator cover gasket took care of it). Sled still runs great.

I would definitely buy one. I like the ones that were available for the nytro and apex, the anodized blue ones with the tuning fork on top.

I'd really like to hear from anyone that is running a studded ripsaw II 1.5. This is what I'm leaning toward after running the ice cobra. It's a good track but I would like more traction. I have the ice build up depending on condition but I take care of it and haven't torn any lugs on my ice...

I'm running it at 50 degrees with heavy hitters and Hurricane's 270 race tune. Over 1000 miles on ultimax belt. I ran with the holeshot helix at first but after some people were saying you shouldn't run that with the race tune, I switched back to the stock helix. I didn't have problems though...

Very cool. Thanks for the share.

Good choice bearhead. I know it's a tough pill to swallow being the OEM is hundreds more than Chinese wannabe stators but for some critical parts OEM is way to go. Sent from my SM-N950U using Tapatalk

I strongly recommend using an OEM stator from Yamaha. Replacing it is a fairly involved job and a huge hassle and extra expense to do multiple times, even if you do it yourself as you will be changing some oil and stator cover gasket each time. I used an RM stator and it lasted around 100...

I got these skinz pads as well, they are thickly cushioned and work really well. Sent from my SM-N950U using Tapatalk

Do not use rm stator.....Should use the OEM stator from yamaha. My rm stator lasted about 100 miles before shorting itself out leaving me stranded and I had to go the OEM route then anyway. Those rm stators are Chinese made junk. Sent from my SM-N950U using Tapatalk

Yup, duece bars work great on the pilots. So do snowtrackers. Make sure you check your toe out and if you need a 1/4 or 3/8 shim under your rubbers as these will both contribute to darting as well. Sent from my SM-N950U using Tapatalk

Has anyone been checked yet this year for sound? Would be great to have folks post their actual DNR tested results with whichever muffler their using.

MrSled, I think under "clutching" where it reads "Do not rotate CCW..." it should read "Always rotate CCW...", right?

I needed a pliers and other tools to bend the pieces back in a bit , it isn't very thin aluminum! Sent from my SM-N950U using Tapatalk

I blew a belt on my turbo nytro this past weekend, sent a chunk clear through the aluminum plate here right into my shin.... This was the only damage. Threw a new belt on, bent the sharp edges on this hole back that looked like it was hit with a grenade launcher and good to go. Belts blowing can...

I was wondering about this too. Sent from my SM-N950U using Tapatalk