Recent content by Ryanmlt1

EDIT: Changed the belt and plugs. It didnt make a differece doesnt want to rev past 6500 without breaking up. Well i took it out 3 more times since it started running bad, trying to diagnose. I dont have a compression tester with me. I will pull the plugs.

I did a high speed pass WOT on my fiances RX1 hit about 85 and it started to loose power. Went to floor it again and it breaks up around 6000 rpm and sounds weird. It wont spin the trqck has no power. Almost like its on 3 cyl. Kinda of worried I lost a piston. It idles fine no back firing...

So I went to the dealer I bought the 06 Apex at yesterday. Was looking at the used sleds and they have a 13 Polaris Switchback Assault 144" 4000mi for $8,400. Showroom condition. Althought he Polaris guys at HCS say should have a top end done. So I just asked not even seriously what he would...

I purchased a used Hauck Y pipe system for my 06 Attak. I was going to install it myslef but from what I see of the Donut install it looks like a real pain. I don't have a lift or a garage. I am mechanically inclined and have the tools but dont want to get into it and not finish outside...

Hi Blue, I took your guys advice and joined the Harvard Club and got my Sam sticker. We rode there trails tonight. We broke trail and got lost alot. They are very tight trails only got to open her up a few times. It was dark as well. They do have a groomer and said they would groom this...

Well because I have mine and my girlfriends and between registering and paying sales tax down here will cost around $500. Its hard to justify $500 for being able to ride a few days a year down here and even if it snows it usually melts in a few days... I just want to play for a few hours...

Does anyone ride in Central MA Clinton/ Berlin or want to? I really just want to tear up some fields im not registered in mass just Maine. Do you know of a good trail. I know some in Berlin but they all require some road riding which I don't prefer since the cops can be tough on recreational...

Thats good advice! I actually went replace it myself but it was so cold -10 and a windchill I just could bare it and new I would break something. I didn't have a garage....

Mike is top notch!! Owner and mechanic.. I was up there the week after New Years, it was -10 and my starter relay went. I called them and his wife relayed my problem to him. He got on the phone and new exactly what it was and said to bring it down and would replace it that night. He must have...

Hi guys, Did a couple hundred miles last weekend and finally got to try this thing out! I love it the power is just incredible and I love the engine breaking! I did notice on the rough trails I was bottoming out on the bigger bumbs... Im 6' 1" 270 so I'm a big guy. Where and what springs...

No I don't have another belt. I will remove the washers. If it comes back I will just get a new belt and start from there. Thank you everyone! I overreacted a little. Its my new baby and I really don't know her history. So when a strange noise appears on my first ride I got concerned.

Ok, Any help with that? Is there a adjustment? Besides the washers on the secondary?

No bogs... But it stops very quickly off throttle. Im not used to it coming off 2 strokes. This was my first ride ever with it doing laps around the yard. So it only happens after shes been ridden for awhile.. I just bought the sled and then brought it to a Yam dealer and had a pre-season...

Hi Guys I have a very loud squeal in the primary after the sled is warmed up and ridden for a little bit. Here is a Video of the sound. Any thoughts? https://www.youtube.com/watch?v=YqnjgILGbUU

Here is a video of it. Watch the whole Video through... I would have taken the covers off but I was freezing and just ran out to take the video. https://www.youtube.com/watch?v=YqnjgILGbUU