Search results

I'm planning to update from a 2004 Aluma 12 foot ride on/off trailer. I bought it used in 2007 and it's been good to me. I'm replacing the wiring harness that has given me some challenges, but I expect that will be sorted out and make a good trailer for the next guy. I know I want an inline...

I'm doing my first track swap. Everything went well until I screwed up the needle bearing in the bottom gear. Ordered a new one from my dealer. Hope it can be pressed in without any problems. Any feedback would be great. Second question. I cleaned up the grease that was on the spacers. What...

I've heard so many good things about the BC track on the XTX. I've wanted one since I was stuck in deep powder the first time, lol. I just wonder if the 1.5 crossover is a better blended option for trail and off trail riding. I just finished putting on 135 excell x wheels and DuPont hyfax...

I just put on my trail tank. I used the permatex and stainless bolts that have been discussed. All went on really well, but, the two bolts that hold on the console cover are off by about an inch. The instructions say the tank will expand making this easier. I think I'll wait to bolt them...

I put on the DuPont hyfax today. It was a bear getting off the original set but the new ones went on pretty well. However, when I was putting the screw back in on the right rail, I think I had tapped on the new hyfax too far which started the thread off. :o| I need to clean up the threads...

I was inspired to lengthen my brake light wire harness and route it under the tunnel while it was apart installing the copper exhaust donuts, trail tank and removal of the tunnel protectors. I relocated the light to the back of the tunnel last season, but it stretched the harness, so I added...

Not good. Tell me that I just need to replace a bolt...please. :o| I checked the threads with another bolt and the threads seem fine. I was torquing down the primary "cover " to 14 nm with an inch lbs wrench I just bought at Harbor Freight. I used a converter on the web to 124 inch lbs from...

I think I'm going to remove my tunnel protectors for ice build up reasons. I plan to put on the 1.75 back country track (someday) anyhow and they'd need to come off. I see the block off plates by OFT and Schmidt bros. How do you like them?

Sorry for the dumb question in advance. I have been searching for help to install the rollers for the Schmidt bros comfort clutch kit. Looking at my stock clutch, the bolts holding the rollers in are not tight. Is that because of the pin sleeve the bolt sits in? I couldn't find an install...

Getting ready for snow. I was lucky to pick up a gently used wrp seat, Schmidt bros comfort clutch and a set of mtn skis with hardware. Since is is Labor Day, I got into polishing the tunnel. Good to get it done. I need to get the more technical stuff done yet. I have a trail tank to...

What do I need to do to swap out the 1.25 ripsaw from my 2011 XTX with a 1.75 BC? Are the drivers compatible? I searched and didn't find a thread. Tunnel protectors need to come out. Is the pitch the same?

After I pulled the rear suspension and was sitting around admiring my first rear skid removal, I decided to see what some Mothers would do for the GYTR front shocks. image by michellelhill1, on Flickr and... image by michellelhill1, on Flickr

I want to swap the 2011 XTX skis on my Nytro to the Mountain Skis, not the MT9s. I thought this would be a simple swap, but, looking at the part numbers on my dealers parts finder site, I'm looking at a small fortune in collars, spacers, bolts, etc. Is this as simple as I'm hoping or does...